Synergistic effect of iodide ions and bark resin of Schinus molle for the corrosion inhibition of API5L X70 pipeline steel in H2SO4

The synergistic effect of bark resin of Schinus molle (BRSM) and iodide ions in 0.5 M sulfuric acid has been studied for the first time by potentiodynamic polarization and electrochemical impedance spectroscopy measurements; also, the surface morphology has been analyzed by scanning electron microscopy–energy-dispersive X-ray spectroscopic analysis in the present work. The results show that the BRSM and iodide ions have an evident synergistic inhibition effect in a 0.5-M sulfuric acid solution. The adsorption of the BRSM/iodide ion system follows the Langmuir adsorption isotherm and acts as a mixed-type inhibitor in sulfuric acid. The BRSM/iodide ion system is an effective inhibitor for API5L X70 pipeline steel in the 0.5-M sulfuric acid solution. The maximum percentage inhibition efficiency is equal to 99% at 1 g/L BRSM + 2 mM KI.     

利用KH560和纳米SiO2采用“一步法”反应挤出增黏PET

以KH560（3-缩水甘油基氧基丙基三甲氧基硅烷）和纳米SiO₂颗粒复配作为扩链剂，采用“一步法”反应挤出增黏聚对苯二甲酸乙二醇酯（PET）。KH560和SiO₂的添加量均为PET质量分数的2.5%时，增黏效果最好。并且在PET不干燥的情况下，KH560和SiO₂复配也可增加PET的黏度，可用作PET的扩链剂和防水解剂。经透射电镜观察，发现SiO₂在PET中的分散状况良好。用FTIR研究了KH560、SiO₂、PET三者之间的反应机理。用TGA分析了SiO₂的接枝率，发现接枝率高达72.0%。用DSC对PET/纳米SiO₂复合材料的结晶行为进行了研究，并讨论了结晶行为对力学性能的影响。当KH560和SiO₂的添加量均为PET质量分数的2.5%时，结晶度最低，综合力学性能最好。     

PP/PCL/石墨/碳纳米管复合材料的制备及电性能分析

采用熔融共混法制备了石墨（G）、碳纳米管（CNTs）与聚丙烯（PP）、聚己内酯（PCL）导电复合材料，通过改变G的添加量制备了系列导电复合材料。主要测试了熔体流动速率、力学性能、导电性能、电热性能，并进行了电子显微镜观察结构、差示扫描量热法分析、热失重分析。结果表明，PCL与PP混合后，PP的拉伸强度提升了4.375 MPa，在加入G/CNTs之后，力学性能受影响较大下降了约73.5 %；G/CNTs的加入还能有效降低PP的电阻率，使其从绝缘体变为半导体材料电阻率为7.83×10⁶ Ω·m；PP与PCL共混后复合材料的热稳定性得到了显著提高，初始分解温度从368.88 ℃升高至398.95 ℃，在加入G/CNTs管后又进一步提高至408.78 ℃。     

咖啡渣活性炭的制备、表征及其对Cr(Ⅵ)的吸附机制研究

以碘吸附值为评价指标，活化时间、活化温度和浸渍比为影响因素，采用响应面法试验设计对磷酸活化法制备咖啡渣活性炭的工艺条件进行优化，并通过静态吸附试验研究了不同吸附时间、溶液pH值和吸附温度条件下，活性炭对水溶液中Cr（Ⅵ）吸附性能的影响，最后利用Langmuir、Freundlich吸附等温方程、准一级动力学方程、准二级动力学方程和颗粒内部扩散方程进行拟合。试验结果表明，制备咖啡渣活性炭的最佳工艺条件为活化时间1 h、活化温度498℃、浸渍比1.72；在此条件下活性炭得率为30.4%，碘吸附值为（799±16）mg/g，比表面积为1 006 m²/g，孔容为0.779 cm³/g、微孔孔容为0.051 cm³/g、平均孔径为3.088 nm。较低pH值和较高温度能够促进活性炭对Cr（Ⅵ）的吸附；Langmuir等温方程能够更好地描述活性炭对Cr（Ⅵ）的吸附效果；活性炭对Cr（Ⅵ）的吸附分3个阶段：快速吸附阶段、慢速吸附阶段和吸附平衡阶段，10 min内可完成吸附总量的79%，360 min内达到吸附平衡，该吸附过程符合准二级吸附动力学方程。分析表明咖啡渣活性炭对Cr（Ⅵ）的吸附主要为单分子层的化学吸附。     

Hydrogen-rich syngas production and carbon dioxide formation using aqueous urea solution in biogas steam reforming by thermodynamic analysis

Biogas is a renewable biofuel that contains a lot of CH₄ and CO₂. Biogas can be used to produce heat and electric power while reducing CH₄, one of greenhouse gas emissions. As a result, it has been getting increasing academic attention. There are some application ways of biogas; biogas can produce hydrogen to feed a fuel cell by reforming process. Urea is also a hydrogen carrier and could produce hydrogen by steam reforming. This study then employes steam reforming of biogas and compares hydrogen-rich syngas production and carbon dioxide with various methane concentrations using steam and aqueous urea solution (AUS) by Thermodynamic analysis. The results show that the utilization of AUS as a replacement for steam enriches the production of H₂ and CO and has a slight CO₂ rise compared with pure biogas steam reforming at a temperature higher than 800 °C. However, CO₂ formation is less than the initial CO₂ in biogas. At the reaction temperature of 700 °C, carbon formation does not occur in the reforming process for steam/biogas ratios higher than 2. These conditions led to the highest H₂, CO production, and reforming efficiency (about 125%). The results can be used as operation data for systems that combine biogas reforming and applied to solid oxide fuel cell (SOFC), which usually operates between 700 °C to 900 °C to generate electric power in the future.     

The performance of green carbon as a backbone for hydrogen storage materials

We investigate the use of carbonized bamboo, which has an organic porous structure, as a hydrogen storage material. Bamboo samples were thermally treated at 800, 900, 1000, and 1100 °C for 24 h. The pore size and hydrogen storage capacity of each sample were measured by N₂ and H₂ gas sorption up to 1.13 bar at 77 K. The maximum hydrogen storage was exhibited by the sample treated at 900 °C, which reached 1.35 wt% at 1.13 bar/77 K. The results showed that the bamboo, one of the green carbons, has the potential to be used as an environmental-friendly carbon backbone for hybrid hydrogen storage materials.     

Determining most effective structural form of nickel-cobalt catalysts for dry reforming of methane

In this study, catalytic activity of carbon dioxide reforming of methane was investigated over nickel-cobalt catalysts in various structural forms. Catalytic activity tests were performed at the temperatures of 600–800 °C in a micro-flow quartz reactor. SEM-EDX, XRD and XPS studies were also performed to understand the surface morphology of the catalysts. The results showed that 8 wt%Ni-2wt.%Co on wash-coated MgO over monolithic structure led to highest catalytic performances with CH₄ and CO₂ conversions of 83% and 89% respectively as well as H₂/CO ratio of 0.95 at 750 °C. SEM-EDX and XPS results of catalyst spent at 750 °C also showed considerable amount of coke formation; however, the use of 3% oxygen in the feed suppressed the coke formation significantly. The catalyst was stable for 48 h in the presence of O₂ (3%) added feed at the temperature of 750 °C.     

Heterostructured thin LaFeO3/g-C3N4 films for efficient photoelectrochemical hydrogen evolution

The deposition of LaFeO₃ at the surface of a graphitic carbon nitride (g-C₃N₄) film via magnetron sputtering followed by oxidation for photoelectrochemical (PEC) water splitting is reported. The LaFeO₃/g-C₃N₄ film was investigated by various characterization techniques including SEM, XRD, Raman spectroscopy, XPS and photo-electrochemical measurements. Our results show that the hydrogen production rate of a g-C₃N₄ film covered by a LaFeO₃ film, exhibiting both a thickness of ca. 50 nm, is of 10.8 μmol h⁻¹ cm⁻² under visible light irradiation. This value is ca. 70% higher than that measured for pure LaFeO₃ and g-C₃N₄ films and confirms the effective separation of electron-hole pairs at the interface of LaFeO₃/g-C₃N₄ films. Moreover, the LaFeO₃/g-C₃N₄ films were demonstrated to be stable and retained a high activity (ca. 70%) after the third reuse.     

Facile synthesis of hybrid porous composites and its porous carbon for enhanced H2 and CH4 storage

The anticipated energy crisis due to the extensive use of limited stock fossil fuels forces the scientific society for find prompt solution for commercialization of hydrogen as a clean source of energy. Hence, convenient and efficient solid-state hydrogen storage adsorbents are required. Additionally, the safe commercialization of huge reservoir natural gas (CH₄) as an on-board vehicle fuel and alternative to gasoline due to its environmentally friendly combustion is also a vital issue. To this end, in this study we report facile synthesis of polymer-based composites for H₂ and CH₄ uptake. The cross-linked polymer and its porous composites with activated carbon were developed through in-situ synthesis method. The mass loadings of activated carbon were varied from 7 to 20 wt%. The developed hybrid porous composites achieved high specific surface area (SSA) of 1420 m²/g and total pore volume (TPV) of 0.932 cm³/g as compared to 695 m²/g and 0.857 cm³/g for pristine porous polymer. Additionally, the porous composite was activated converted to a highly porous carbon material achieving SSA and TPV of 2679 m²/g and 1.335 cm³/g, respectively. The H₂ adsorption for all developed porous materials was studied at 77 and 298 K and 20 bar achieving excess uptake of 4.4 wt% and 0.17 wt% respectively, which is comparable to the highest reported value for porous carbon. Furthermore, the developed porous materials achieved CH₄ uptake of 8.15 mmol/g at 298 K and 20 bar which is also among the top reported values for porous carbon.     

煤化工烟道气毒性成分对Chlorella pyrenoidosa生长和细胞成分的影响

探究煤化工烟道气中毒性成分对微藻的影响是利用微藻固定煤化工烟道气CO₂实现减排的关键。本文利用不同浓度的NaHS、Na₂SO₃和NH₃·H₂O培养Chlorella pyrenoidosa（C. pyrenoidosa），以探究煤化工烟道气主要毒性成分H₂S、SO₂和NH₃气体水溶物的毒性。实验结果表明：NaHS、Na₂SO₃和NH₃·H₂O浓度分别低于1mmol/(L·d)、40mmol/(L·d)和7mmol/(L·d)时对C. pyrenoidosa生长无抑制作用，而且Na₂SO₃[＜40mmol/(L·d)]会显著促进 C. pyrenoidosa的生长；NaHS 添加4mmol/(L·d)时会在生长初期抑制C. pyrenoidosa的生长，NH₃·H₂O添加35mmol/(L·d)则会直接造成藻细胞的破碎死亡。与对照组相比，NaHS和Na₂SO₃浓度分别低于1mmol/(L·d)、10mmol/(L·d)时对C. pyrenoidosa的细胞成分无影响；NaHS添加4mmol/(L·d)使藻蛋白含量提高7.13%；Na₂SO₃添加40mmol/(L·d)使藻蛋白降低13.45%，总糖含量提高42.90%；NH₃·H₂O的添加会使藻蛋白含量降低，总糖含量提高。微藻生物质整体蛋白质含量较高，可作为蛋白饲料来源。研究结果表明，C. pyrenoidosa对煤化工烟道气中的主要毒性气体有较好的耐受性，利用煤化工烟道气培养微藻具有可行性。